Advanced
An Improvement of Closed-Form Formula for Mutual Impedance Computation
An Improvement of Closed-Form Formula for Mutual Impedance Computation
Journal of electromagnetic engineering and science. 2013. Dec, 13(4): 240-244
Copyright ©2013, The Korean Institute of Electromagnetic Engineering and Science
This is an Open-Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/3.0) which permitsunrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
  • Received : November 13, 2013
  • Accepted : December 11, 2013
  • Published : December 31, 2013
Download
PDF
e-PUB
PubReader
PPT
Export by style
Article
Author
Metrics
Cited by
TagCloud
About the Authors
Trinh-Van, Son
Division of Electronics and Electrical Engineering, Dongguk University, Seoul, Korea.
Keum Cheol, Hwang
Division of Electronics and Electrical Engineering, Dongguk University, Seoul, Korea.
kchwang@dongguk.edu
Joon-Young, Park
Core Technology Group, Samsung Thales, Yongin, Korea.
Seon-Joo, Kim
3rd R&D Institute, Agency for Defense Development, Daejeon, Korea.
Jae-Ho, Shin
Division of Electronics and Electrical Engineering, Dongguk University, Seoul, Korea.

Abstract
In this paper, we present an improvement of a closed-form formula for mutual impedance computation. Depending on the center-to-center spacing between two rectangular microstrip patch antennas, the mutual impedance formula is separated into two parts. The formula based on synthetic asymptote and variable separation is utilized for spacings of more than 0.5 λ 0 . When the spacing is less than 0.5 λ 0 , an approximate formula is proposed to improve the computation for closely spaced elements. Simulation results are compared to computational results of mutual impedances and mutual coupling coefficients as functions of normalized center-to-center spacing in both E- and H-plane coupling configurations. A good agreement between simulation and computation is achieved.
Keywords
Ⅰ. INTRODUCTION
The design of a finite array requires an accurate determination of the mutual impedance between two elements and the mutual impedance matrix of whole array. An accurate approach using the moment method has been proposed for mutual impedance computation [1] . However, the moment method requires that each element be segmented into many basis functions; therefore, this method becomes tedious and time consuming as the number of elements in array increases. Several methods have been proposed that deal with the mutual impedance computation based on simplified models such as the transmission line model [2] , and the magnetic current approximation [3] . These methods are much faster but may be inaccurate. Recently, a closed-form mutual impedance formula has been proposed, which is based on synthetic asymptote and variable separation [4 - 6] . In this formula, only 12 unknown coefficients are determined by matching with the simulated data or measured data. Therefore, this method is very fast and accurate due to its use of a synthetic asymptote form of the separated variables of the center-to-center spacing and the azimuth angle between two elements. However, when the center-to-center spacing is less than 0.5 λ 0 ( λ 0 is the free-space wavelength), the computational result for very closely spaced elements is incorrect if this formula is used.
In this paper, we propose a method to improve the closed- form formula for the mutual impedance computation between two very closely spaced elements. The mutual impedance formula is separated into two parts depending on the center-to-center spacing between two elements. When the spacing is more than 0.5 λ 0 , the mutual impedance is computed by utilizing the synthetic asymptote formula [4] . An approximate formula is proposed when the spacing is less than 0.5 λ 0 . The simulated and computational results agree well in terms of mutual impedances and mutual coupling coefficients between two closely spaced microstrip patches in E-plane and H-plane.
Lager Image
Geometry of two coupled rectangular microstrip patch antennas.
Ⅱ. FORMULATIONS
Fig. 1 shows the geometry of two coupled microstrip patch antennas. These antennas are designed to operate at 5 GHz on the dielectric substrate with εr =2.55 and thickness h =1.57 mm. The dimension of patch is determined as W×L =22.6 mm×17.52 mm. The feed point is located at the center of W with the distance a =5mm. In this work, we only focus on the mutual coupling between two patches in E- and H-plane coupling configurations. The mutual impedance formula is separated into two parts corresponding to the spacing r less than 0.5 λ 0 and more than 0.5 λ 0 .
- 1. The Mutual Impedance Formula Based on the Synthetic Asymptote and Variable Separation
When the center-to-center spacing r between two patches is more than 0.5 λ 0 , the closed-form mutual impedance formula based on the synthetic asymptote and variable separation is utilized. In this method, the mutual impedance can be written as a function of spacing r and the azimuth angle φ , as shown in Fig. 2 (a). The use of a synthetic asymptote form of separated variables of spacing r and angle φ , gives the following as the mutual impedance between the two elements [4]
Lager Image
where η 0 is the intrinsis impedance of free space, k 0 is the free space wave number, and the unknown complex coefficients Cn,m ( n = 1/2, 0, 1, 2 and m =0, 2, 4) must be-determined. These 12 coefficients can be found by matching with the simulated results of mutual impedance between center patch “0” and 12 coupled patches in a skeleton array, as shown in Fig. 2 (b). The 12 models consisting of the center patch “0” and each of 12 coupled patches with the respective spacing set in skeleton array are simulated to obtain the mutual impedances at resonant frequency. From 12 values of the simulated mutual impedances, the Eq. (1) can be used to establish a set of 12 independent equations to be solved for the 12 coefficients Cn,m by matrix inversion.
Lager Image
(a) Coordinates of two coupled patches and (b) skeletonarray configuration.
- 2. The Approximate Mutual Impedance Formula for Closely Spaced Elements
As mentioned above, when the spacing r is less than 0.5 λ 0 , the computation of mutual impedance for closely spaced elements obtained using Eq. (1) is incorrect. Therefore, we propose an approximate formula to improve the computation for two very closely spaced elements. It is worth noting that the mutual impedance between two elements in E- or Hplane coupling configuration only depends on the spacing r . Several sampling values of the spacing r are chosen and the simulated results of mutual impedances are obtained through simulation. By fitting some curves to the simulated data, the mutual impedance formulas for E- and H-plane can be expressed as
Lager Image
for E-plane coupling configuration, and
Lager Image
for H-plane coupling configuration. By combining Eq. (2) or Eq. (3) with Eq. (1), the mutual impedance between two elements in the E- and H-plane, respectively, can be accurately computed even through the center-to-center spacing r is less than 0.5 λ 0 .
Ⅲ. RESULTS AND DISCUSSION
Fig. 3 plots the simulated reflection coefficients versus frequency of two microstrip patch antennas at the center-tocenter spacing of 0.5 λ 0 , . The simulation was conducted by using Ansys High-Frequency Structure Simulator (HFSS) based on the three-dimensional finite element method. The two patches operate at the same resonant frequency of 5 GHz.
First, the 12 unknown coefficients Cn,m in Eq. (1) must be determined by matching with the simulated data. The 12 coupled patches on the skeleton array are arranged with the fixed sampling points as shown in Fig. 2 (b). The 12 coefficients Cn,m are computed and listed in Table 1 .
Lager Image
Simulated reflection coefficients of two microstrip patchantennas.
The 12 complex coefficientsCn,m
Lager Image
The 12 complex coefficients Cn,m
Once the 12 coefficients Cn,m of Eq. (1) have been obtained, the mutual impedance between the two patch antennas is calculated by combining Eq. (1) with Eq. (2) for the E-plane coupling configuration or with Eq. (3) for the Hplane coupling configuration. Figs. 4 and 5 show the mutual impedances versus normalized center-to-center spacing r between two patches in the E- and H-plane from simulation, and from computation using synthetic asymptote formula, and our proposed formula. Clearly, when the spacing r is more than 0.5 λ 0 , the computation results agree well with the simulation results. When the spacing r is less than 0.5 λ 0 , the results of mutual impedance using the synthetic asymptote formula are very different compared to the simulation results, especially the imaginary part of the mutual impedance. However, the use of our proposed formula to enhance the computation with the closely spaced elements achieves a good agreement between the simulation and computation.
Overlapping is avoided by choosing the minimum values of center-to-center spacing r as 0.3 λ 0 and 0.38 λ 0 for the E- and H-plane couping configurations, respectively. Table 2 shows the comparison between the simulation and computation results of the mutual impedance corresponding to the minimum spacing r . Good agreement between our formula and the simulation is observed.
The mutual coupling Sab between two patches expressed in decibels can be defined as [7]
Lager Image
where Zaa is the self-impedance of the patch, Zab is the mutual impedance between the two patches, and Z 0 is the feed line impedance. We typically assume Zaa = Z 0 =50. Figs. 6 and 7 show the results of the mutual coupling versus normalized spacing r in the E-plane and H-plane coupled configurations, respectively. Clearly, the computation results using our formula and asymptote formula agree well with the simulation results, except for the greater difference in the E-plane coupling configuration from the asymptote formula when the spacing r is less than the half-wavelength.
Comparison of mutual impedance with the minimum spacing
Lager Image
Comparison of mutual impedance with the minimum spacing
Lager Image
Mutual impedance versus normalized center-to-center spacingbetween two patches in E-plane coupled configuration.
Lager Image
Mutual impedance versus normalized center-to-center spacingbetween two patches in H-plane coupled configuration.
Lager Image
Comparison of mutual coupling between two patches inE-plane coupled configuration.
Lager Image
Comparison of mutual coupling between two patches inH-plane coupled configuration.
Ⅳ. CONCLUSION
An improvement in the closed-form formula for mutual impedance computation between two very closely spaced microstrip antennas in E- and H-plane has been presented. A good agreement was achieved between the simulation and computation. The computational results show that the proposed approach is feasible for application to the design of linear microstrip patch arrays with arbitrary element spacing.
Acknowledgements
This research was support by Agency for Defense Development(Dual band/Multibeam RF Tech. for RADAR,UC110D13FD).
References
Pozar D. M. 1982 "Input impedance and mutual coupling ofrectangular microstrip antennas" IEEE Transactions on Antennas and Propagation 30 (6) 1191 - 1196    DOI : 10.1109/TAP.1982.1142934
Van Lil E. , Van de Capelle A. 1984 "Transmission linemodel for mutual coupling between microstrip antennas" IEEE Transactions on Antennas and Propagation 32 (8) 816 - 821    DOI : 10.1109/TAP.1984.1143416
Malkomes M. 1982 "Mutual coupling between microstrip patch antennas" IEEE Electronics Letters 18 (2) 520 - 522    DOI : 10.1049/el:19820353
Sun Y. X. , Chow Y. L. , Fang D. G. 2002 "Mutual impedanceformula between patch antennas based on syntheticasymptote and variable separation" Microwave and Optical Technology Letters 35 (6) 466 - 470    DOI : 10.1002/mop.10640
Xi Y. P. , Fang D. G. , Sun Y. X. , Chow Y. L. 2005 "Mutual coupling in finite microstrip patch arrays" Microwave and Optical Technology Letters 44 (6) 577 - 581    DOI : 10.1002/mop.20701
Wang H. , Fang D. G. , Chen B. , Tang X. , Chow Y. L. , Xi Y. 2009 "An effective analysis method for electricallylarge finite microstrip antenna arrays" IEEE Transactions on Antennas and Propagation 57 (1) 94 - 101    DOI : 10.1109/TAP.2008.2009669
Khayat M. A. , Williams J. T. , Jackson D. R. , Long S. A. 2000 "Mutual coupling between reduced surface-wavemicrostrip antennas" IEEE Transactions on Antennas and Propagation 48 (10) 1581 - 1593    DOI : 10.1109/8.899675