A compact (0.26×0.05
λ
0
at 2.27 GHz) metamaterial-based zeroth-order resonant antenna system consisting of epsilon- negative (ENG) and mu-negative (MNG) structures is proposed. Although the spacing between the ENG and MNG antennas is only 0.09
λ
0
, the isolation is relatively high (27.6 dB at 2.27 GHz). Furthermore, the envelope correlation is only 0.015. The radiation efficiencies of the proposed two radiators are also very high (90% on average).
Ⅰ. Introduction
Multiple-input multiple-output (MIMO) technology is now widely employed in order to increase the reliability and the channel capacity of modern wireless communication systems. However, the available space for antennas in recent mobile terminals is very limited. Moreover, meeting the requirements of compact size, high isolation, low envelope correlation, and high radiation efficiencies in limited space usually available is quite challenging
[1
,
2]
. To achieve these goals, many antenna structures have been proposed. In
[3]
, a planar inverted- F antenna (PIFA) with a dual-feed was presented. Two PIFAs are placed at the corners of a mobile terminal for the largest possible separation, utilizing polarization diversity
[4]
. There have been trials to use photonic band-gap or split ring resonator
[5]
structures between the radiation elements in order to improve the isolation. A decoupling network
[6]
is one promising means of satisfying the MIMO requirements. However, these two methods require an additional structure or circuit between the antennas. To overcome this problem, we adopt two types of metamaterial (MTM) zeroth-order resonant (ZOR) antennas. One is the epsilon-negative (ENG; open terminated) antenna, and the other is the mu-negative (MNG; short terminated) antenna
[7]
. It is well known that MTM ZOR antennas can be made as small as possible. In addition, it will be shown that the performance of the proposed MIMO system far surpass those of recent works in terms of the size, isolation, envelope correlation, and antenna efficiencies.
Ⅱ. Antenna Design and Simulation
Fig. 1
shows the geometry of the proposed MIMO system composed of the ZOR ENG and MNG antennas with their dimensions designed at 2.2 GHz. The antennas are fed by two 50 Ω microstrip lines with width of 7.5 mm on a Teflon substrate (
εr
, 2.2; height, 2.37 mm). Since the ENG antenna has an open termination and its propagation constant
β
is zero (zeroth-order), the series current is negligible and the shunt voltage wave (or electrical field) is dominant in the entire structure with the same phase. For the MNG antenna with a short termination, the opposite is true with a dominant series current. The electric fields generated by this current are orthogonal to those in the ENG antenna. For this reason, the coupling between the two antenna elements becomes very small.
Geometry of proposed multiple-input multiple-output system consisting of epsilon-negative (ENG) and mu-negative (MNG) antennas (unit: mm).
In
Fig. 2
, we show the equivalent circuit of the MNG antenna short-terminated. The electrical length
kd
of the host transmission line is
π
/6 radians at 2.4 GHz and the characteristic impedance
Zc
is 50 Ω. This is equivalent to the fact that the series inductance
Ld
is 1.74 nH and the shunt capacitance
Cd
is 0.69 pF. Since the propagation constant
β
is required to be 0 at the transient frequency of
f
0
=2.4 GHz,
C
0
is determined to be 2.5 pF
[7]
. Furthermore,
R
0
is extracted to be 0.23 Ω. Since
R
0
is very small and direct matching to the feed line is not possible, a coupling inductor with
L
1
is usually required. By equating the input admittance
Yin
to the characteristic admittance
Yc
of the feed line, we can find a new resonant angular frequency
ω
1
given by
and
L
1
is found to be
In (1), as
R
0
→
Zc
or 0,
ω
1
→
ω
0
, and
ω
1
becomes the lowest when
R
0
is
Zc
/2. Using (1) and (2), the new resonant frequency
f
1
becomes 2.23 GHz and
L
1
is calculated to be 0.23 nH, realized using three vias with radius 0.5 mm as seen in
Fig. 1
.
For the ENG, the equivalent circuit is exactly the dual of
Fig. 2
[8]
. The calculated shunt inductance
L
0
is 6.2 nH, realized with a shorted stub, and
G
0
is extracted to be 0.0001 S. The coupling capacitance
C
1
for matching to the feed line is 0.1 pF, realized with a gap, as seen in
Fig. 1
. The overall MIMO antenna system is very compact (0.26×0.05
λ
0
).
Fig. 3
shows the photograph of the MIMO system consisting of ENG and MNG antennas. Two feed lines have been somewhat bent away from each other for easy mounting of SMA connectors.
Fig. 4
(a) and (b) show the electromagnetic (EM)-simulated and measured |
S
11
| (ENG), |
S
22
| (MNG), and |
S
21
|. Their resonant frequencies are shown to be off by about 0.04 GHz, possibly due to fabrication inaccuracy. The EM-simulated and measured resonant frequencies are 2.23 and 2.27 GHz, respectively. Although the spacing between the ENG and MNG is only 0.09
λ
0
, the isolation (|
S
21
|) which has been measured using a network analyzer is relatively high (27.6 dB) at 2.27 GHz.
Equivalent circuit for the short-terminated mu-negative antenna.
Fabricated multiple-input multiple-output system.
Electromagnetic (EM)-simulated and measured S-parameters of the proposed antenna: (a) |S11|, |S22| and (b) |S21|.
Electromagnetic (EM)-simulated and measured gain patterns in yz plane: (a) Eθ and (b) Eϕ. ENG=epsilon-negative, MNG=mu-negative.
In
Fig. 5
(a) and (b), we show the gain patterns
Eθ
and
Eϕ
of the ENG and MNG antennas, respectively, in the yz plane. The EM-simulated and measured patterns of
Eϕ
are in a better agreement than those of
Eθ
. The difference between the EM-simulated and measured pattern of
Eθ
is believed to come from the fabrication error. Due to the small size of the antennas and ground plane, they show near-isotropic patterns. The envelope correlation
[9]
of the proposed antenna has been computed to be very small (0.015). This result is due to the near-orthogonally radiated fields, evaluated over all 4
π
solid angles.
Comparison of multiple-input multiple-output antenna performances
Comparison of multiple-input multiple-output antenna performances
In
Table 1
, the various performances of the proposed antennas are compared with those in
[4]
(A type),
[5]
(B type), and
[6]
(C type), and the proposed antennas prove to be superior to the others to the best of our knowledge. The gains and radiation efficiencies of the each antenna were measured while the one port was connected to the source and the other one was matched.
Ⅲ. Conclusion
A very compact MTM-based ZOR MIMO system consisting of ENG and MNG structures has been designed, fabricated, and evaluated in terms of its size, isolation, envelope correlation, and radiation efficiencies. The performances of the proposed antenna have been compared with those of recent competitive works. Despite the small separation (0.09
λ
0
) between the proposed radiation elements, the isolation is relatively high (27.6 dB) at 2.27 GHz. The envelope correlation has been found to be negligibly small (0.015). The efficiencies are about 90% on average. The proposed ZOR MIMO antenna system is considered to be an immediate candidate for the very compact mobile handsets of today.
Acknowledgements
This work was supported by the Mid-career Researcher Program through the National Research Foundation of Korea (NRF) grant funded by the Korea government (No. 2012047938).
Svantesson T.
2002
"Correlation and channel capacity of MIMO systems employing multimode antennas"
IEEE Transactions on Vehicular Technology
51
(6)
1304 -
1312
DOI : 10.1109/TVT.2002.804856
Kildal P. S.
,
Rosengren K.
2004
"Correlation and capacity of MIMO systems and mutual coupling, radiation efficiency, and diversity gain of their antennas: simulations and measurements in a reverberation chamber"
IEEE Communications Magazine
42
(12)
104 -
112
DOI : 10.1109/MCOM.2004.1367562
Chattha H. T.
,
Huang Y.
,
Boyes S. J.
,
Zhu X.
2012
"Polarization and pattern diversity-based dual-feed planar inverted-F antenna"
IEEE Transactions on Antennas Propagation
60
(3)
1532 -
1539
DOI : 10.1109/TAP.2011.2180308
Al-Nuaimi M. K. T.
,
Whittow W. G.
2011
"Performance investigation of a dual element IFA array at 3 GHz for MIMO terminals"
in Proceedings of the Loughborough Antennas & Propagation Conference
Loughborough, UK
1 -
5
Bait-Suwailam M. M.
,
Boybay M. S.
,
Ramahi O, M.
2010
"Electromagnetic coupling reduction in highprofile monopole antennas using single-negative magnetic metamaterials for MIMO applications"
IEEE Transactions on Antennas Propagation
58
(9)
2894 -
2902
DOI : 10.1109/TAP.2010.2052560
Chen S. C.
,
Wang Y. S.
,
Chung S. J.
2008
"A decoupling technique for increasing the port isolation between two strongly coupled antennas"
IEEE Transactions on Antennas and Propagation
56
(12)
3650 -
3658
DOI : 10.1109/TAP.2008.2005469
Jang S.
,
Lee B.
2011
"Modelling and design of resonant one-dimensional metamaterial-based transmission lines for antenna applications"
IET Microwaves Antennas & Propagation
5
(13)
1529 -
1536
DOI : 10.1049/iet-map.2010.0452
Kim T. G.
,
Lee B.
2009
"Metamaterial-based compact zeroth-order resonant antenna"
Electronics Letters
45
(1)
12 -
13
DOI : 10.1049/el:20092715
Blanch S.
,
Romeu J.
,
Cordella I.
2003
"Exact representation of antenna system diversity performance from input parameter description"
Electronics Letters
39
(9)
705 -
707
DOI : 10.1049/el:20030495